SDB150CCW by Jason Industrial | Spiral Double Bolt Hose Clamp for Corrugated Hose | Counterclockwise | Fits: 1-1/2" Hose OD
Buy more, save moreDiscounts applied in cart/checkout.
Clamps
Jason Industrial | Spiral Double Bolt Hose Clamp for Corrugated Hose
Clamps (for corrugated hose) manufactured in either clockwise (right hand) or counter clockwise (left hand) design, the spiral double bolt clamp fits between the convolutions on corrugated hose. When fully tightened, the wire secures the full circumference of the outside hose wall - not the convolutions, for a safe, economical and efficient securing method. Consult hose manufacturer for correct convolution direction. Direction of clamp spiral and hose convolution are the same.
1
What is this product used for?
- Secure clamp for corrugated hose.
2
What are the main product features?
- Manufactured in either clockwise (right hand) or counter clockwise (left hand) design
- The spiral double bolt clamp fits between the convolutions on corrugated hose.
- When fully tightened, the wire secures the full circumference of the outside hose wall - not the convolutions, for a safe, economical and efficient securing method.
3
What are the Instructions for Installing Spiral Double Bolt Hose Clamps?
- Bolts should be assembled dry.
- Proper clamp part number should be selected from chart to fit the appropriate size and corrugation direction of hose.
- Assemble the clamp onto a squarely cut hose fully inserted with all clamp components in alignment.
- Bolts should be hand tightened until resistance is met as the hose is contacting the clamp saddle and inside of bolt arcs.
- The bolt ends/nuts should be tightened sequentially one turn at a time to gradually pull the clamp halves evenly.
- Fully torque the nuts in this manner until the values shown in the chart are achieved. Do not exceed the recommended torque.
- Hoses will compress (cold flow) over time and periodically the bolts will need to be retorqued for optimum performance of the assembly. It is recommended that this retorquing be done daily for the first week of use, then check monthly as part of maintenance.
- WARNING! Re-tightening of clamps is necessary before each use. Regular inspection of the assembly is recommended. Always refer to manufacturer’s recommendations for torque and tightening sequence.
4
Which sizes or configurations are available?
| Clockwise Part Number |
Counterclockwise Part Number |
Hose O.D. Range | Torquelbf-ft. | |
|---|---|---|---|---|
| From | To | |||
| SDB150CW | SDB150CCW | 1-1/2" | 15 lb-ft | |
| SDB200CW | SDB200CCW | 2" | 15 lb-ft | |
| SDB250CW | SDB250CCW | 2-1/2" | 15 lb-ft | |
| SDB300CW | SDB300CCW | 3" | 27 lb-ft | |
| SDB400CW | SDB400CCW | 4" | 27 lb-ft | |
| SDB500CW | SDB500CCW | 5" | 60 lb-ft | |
| SDB600CW | SDB600CCW | 6" | 60 lb-ft | |
| SDB800CW | SDB800CCW | 8" | 60 lb-ft | |
| SDB1000CW | SDB1000CCW | 10" | 60 lb-ft | |
| SDB1200CW | SDB1200CCW | 12" | 60 lb-ft | |
Additional Product Data:
Material(s):
Maximum Clamp I.D.:
1.5in
